Get in Touch
  1. Home >
  2. News >
  3. Why does the concrete crusher not pump water?

Why does the concrete crusher not pump water?

The oil temperature is too high 2 Oil temperature and pressure rise 3Oil pressure is low after oil pump is started 4Oil contain lots of fine mud and impurities 5There is water in the oil 6The vibration of cone crusher is too strong 7 The crushing cone rotates very high

Get Price

Related Products

Contact Us

[email protected]

Kexue Revenue, High and New Technology Industrial Development Zone, Zhengzhou, China

Get Latest Price
Get in Touch

If you have any problems about our product and service,please feel free to give your inquiry in the form below. We will reply you within 24 hours as soon as possible.Thank you!

I accept the Data Protection Declaration

Popular products

  • water seeping through basement floor and what to

    how does water get into the basement water will find its way in the basement through one of these 2 places basement floor cracks and foundation wall cracks or in the mortar cove joints joints where the concrete is poured this can happen over time if the houses foundation shifts causing a gap where the basement wall meets the floor

    Read More
  • the complete guide to crushed stone and gravel

    nov 11 2019 a geological definition of gravel is a natural material that consists of watertransported materials and usually has a rounded shape as a result of the water transport one of the key differences in the look and feel of crushed stone and gravel is the edges of the stone

    Read More
  • gravel to control water accumulation home guides

    jan 30 2021 gravel to control water accumulation if puddles are the problem gravel could be the answer unwanted water accumulation makes paths messy

    Read More
  • wet sloppy muddy driveway cr4 discussion thread

    mar 28 2010 the drive is long and water is the problem so why not hire and learn to drive it yourself one of those little jcb type excavators i have driven them in 5 minutes you are a professional then excavate a drain on either side and lay concreteplastic pipe with drains into the pipe at suitable intervals to carry the water away from the drive

    Read More
  • pumping of concrete system working and problems

    pumping of concrete is economical if the quantity of concrete required is more than about 1150 m 3 or uninterrupted supply of concrete is needed over a long period as at the beginning of each period of pump ing the pipes have to be lubricated by mortar at the rate of about 025 in 3 per 1000 m length of 150 mm diameter pipe and also at the end of the operation considerable effort is needed

    Read More
  • top 16 mistakes people make when installing concrete

    concrete does not reach its greatest strength when there is a disparity between moisture content during the curing process the water integrated into the original mix evaporates from the surface and may cause cracking if some of the water is not replenished to restore some of the balance between the interior and surface of the concrete

    Read More
  • concrete slab surface defects causes prevention repair

    bleeding capacity with little or no bleed water on the surface silica fume concrete is prone to plastic shrinkage cracking on hot windy days fogging the air above the concrete and erecting windshades lessen the risk of plasticshrinkage cracking concrete has

    Read More
  • 14 cone crusher common problems and how to fix

    jul 22 2019 the oil temperature is too high 2 oil temperature and pressure rise 3oil pressure is low after oil pump is started 4oil contain lots of fine mud and impurities 5there is water in the oil 6the vibration of cone crusher is too strong 7 the crushing cone rotates very high

    Read More
  • slump adjustment is a fact of life for concrete

    concrete to be pumped usually requires a high slump adding superplasticizers onsite instead of water can obtain a pumpable mix without increasing the watercement ratio prolonged delivery waiting and unloading times can cause a decrease in slump

    Read More
  • stormwater best management practices concrete washout

    does not reach the soil surface and then migrate to surface waters or into the ground water and b recycle 100 percent of the collected concrete washout water and solids another description of concrete washout at construction sites concrete and its ingredients concrete is a mixture of cement water and aggregate material

    Read More
  • sprinkler pump troubleshooting tractor supply co

    jul 26 2019 symptom 4 pump moves water but not enough if your sprinkler pump is not moving enough water there are a few possible causes the pump is sucking air the depthtowater in the water well is too deep the motor is operating on the wrong voltage the sprinkler system simply requires more water than the pump can supply

    Read More
  • fly ash concrete what are the reasons for

    the benefits of fly ash in concrete workability concrete is easier to place with less effort ease of pumping pumping requires less energy and longer pumping distances are possible improved finishing concrete is creamier with clear sharp architectural patterns easier to achieve reduced bleeding fewer bleed channels decrease permeability

    Read More
  • 5 reasons why concrete cracks wise cracks

    the wetter or soupier the concrete mix the greater the shrinkage will be 2 concrete drying too fast also rapid drying of the slab will significantly increase the possibility of cracking the chemical reaction which causes concrete to go from the liquid or plastic state or a solid state requires water

    Read More
  • concrete scientific principles

    concrete does not need to dry out in order to harden as commonly thought the concrete or specifically the cement in it needs moisture to hydrate and cure harden when concrete dries it actually stops getting stronger concrete with too little water may be dry but is not fully reacted

    Read More
  • how to remove and prevent concrete efflorescence

    aug 12 2021 how to remove the problem the easiest step to remove efflorescence is to wash the wall and scrub the area to see if the stains go away you will need to use only clear water to avoid worsening the situation the sooner the better as time will

    Read More
  • septic drain field problems dont replace your drainfield

    many people with septic system problems such as odor slow draining sinks and tubs gurgling pipes backups and sewage water ponding in their yard mistakenly assume the cause of these issues is their septic tank this however is not true the most common cause of septic system problems and failure is their septic system absorption component more commonly known as a drainfield becoming

    Read More
  • the complete guide to crushed stone and gravel

    nov 11 2019 a geological definition of gravel is a natural material that consists of watertransported materials and usually has a rounded shape as a result of the water transport one of the key differences in the look and feel of crushed stone and gravel is the edges of the stone

    Read More
  • 7 problems with gunite pools that you need to know

    mar 06 2013 surface is a wear item you need to replace it now whether or not you have salt in your water a concrete pool will need to be resurfaced at best 710 years is all that can be expected now keep in mind the price 15000 to 20000 is a good starting point for a 15 x 30 pool

    Read More
  • why we crush concrete cube or cylinder samples at 28 days

    apr 01 2018 the crushing of concrete cubes or cylinder samples is required in a construction especially concrete structures the reason why this is to verify the strength given in the design mix let say for example for a concrete column commonly it has 60 megapascals of specified strength when you crush it the result should be equal or more than 60 mpa the specified strength should be achieved at

    Read More
  • gravel to control water accumulation home guides sf gate

    jan 30 2021 gravel to control water accumulation if puddles are the problem gravel could be the answer unwanted water accumulation makes paths messy

    Read More
  • wet sloppy muddy driveway cr4 discussion thread

    mar 28 2010 the drive is long and water is the problem so why not hire and learn to drive it yourself one of those little jcb type excavators i have driven them in 5 minutes you are a professional then excavate a drain on either side and lay concreteplastic pipe with drains into the pipe at suitable intervals to carry the water away from the drive

    Read More
  • sump pump pit doesnt stop getting water for at least 1

    one other thought you do not want the pump down in the bottom 34 inches of the sump or it will pick up silt and such which should be bailed out by hand every few years to extend pump life but if it is set too high it is not signficantly drawing down the water level under the salb when it pumps out so it might be shortcycling for that

    Read More
  • concrete slab surface defects causes prevention repair

    2 minimize the mix water content by maximizing the size and amount of coarse aggregate and use lowshrinkage aggregate 3 use the lowest amount of mix water required for workability do not permit overly wet consistencies 4 avoid calcium chloride admixtures 5 prevent rapid loss of surface moisture while the concrete is

    Read More
  • 14 cone crusher common problems and how to fix them

    the oil temperature is too high 2 oil temperature and pressure rise 3oil pressure is low after oil pump is started 4oil contain lots of fine mud and impurities 5there is water in the oil 6the vibration of cone crusher is too strong 7 the crushing cone rotates very high

    Read More
Recently updated
kf
Online Chat Get Quotation
kf